High bass 50 Watt Sub-woofer Amplifier with Sub-filter Circuit Diagram

Hello Friends,
Welcome to Electronics Tube Blog-spot,

In this blog I will be sharing you an amazing circuit diagram for a power-full sub-woofer for indoor use.The circuit is very easy and cheap to be assembled. This circuit was built and tested by me on a 12” Subwoofer. The bass quality was awesome . The circuit is cheap to be assembled as it is powered using single supply. The components used in this circuit are low priced as well easily available around the market. This circuit can be also used for car sub-woofers if built in two channel mode. Each would have output power of around 50 Watts.

About the Circuit Diagram for 50 Watts Amplifier

The filter of the circuit is built around popular LM358 Dual op-amp. The audio input can be directly fed to the input of filter stage . The output of the LM358 drives the power amplifier stage which is built using TDA 2030 audio chip along with MJE3055 and MJE2955 ( Complementary Transistors  Pd = 75-Watts ). The circuit is powered using a single supply. The  maximum dc input voltage for the circuit is +18 volts. Higher voltages may damage TDA2030 Audio Chip.

Sub-woofer Specs : 
10-inch to 12-inch, having input impedance of around 4-Ohm.
The circuit can be assembled on a good quality PCB.

Looking for the circuit diagram for 50 watt stereo amplifier ?


If any doubts or issue please comment below . For latest post subscribe to my blog.
To appreciate comment below :



Thankyou
-Aniket Singh

Comments

Popular posts from this blog

Best 5 Power Transistors for Audio Power Amplifiers | Complementary Pairs

50+50 Watt Hi-Fi Power Amplifier Circuit with PCB Assembly Single Supply

Homemade 4.1 Amplifier Circuit Diagram using TDA2030 / LM358/ MJE3055/ MJE2955